Breville Juicer Breville ikon 800JEXL Die-Cast Juice Fountain Elite User Manual

4.1

Out of 7 Ratings

Owner's of the Breville Juicer Breville ikon 800JEXL Die-Cast Juice Fountain Elite gave it a score of 4.1 out of 5. Here's how the scores stacked up:

  • Reliability

    4.17 out of 5

  • Durability

    4.17 out of 5

  • Maintenance

    3.71 out of 5

  • Performance

    4.33 out of 5

  • Ease of Use

    4.33 out of 5
of 80
 
13
OPERATING YOUR BREVILLE PRODUCT
1. Wash your selection of fruit and
vegetables ready for juicing.
NOTE
Most fruit and vegetables such as
apples, carrots and cucumbers will
not need to be cut to size as these will
fit into the feed chute whole. When
juicing carrots place the tip of the
carrot into the feed chute last.
2. Ensure the juicer is correctly assembled.
Ensure the Stainless Steel Filter is
thoroughly cleaned before each use.
Ensure you place the Juice Jug under
spout before commencing juicing.
3. Plug the power cord into a 110 or 120V
power outlet. Flip the two-speed switch
either up for low speed or down for high
speed depending on the type of fruit
or vegetable being juiced and the unit
will automatically start. Use the speed
selector table as a guide for juicing
different fruits and vegetables.
4. With the motor running, place food into
the Feed Chute. Using the Food Pusher,
gently guide food down the Feed Chute.
To extract the maximum amount of
juice, always push the Food Pusher
down slowly.
5. Juice will flow into the Juice Jug and the
separated pulp will accumulate in the
Pulp Container.
WARNING
Never use fingers to push food down
the feed chute or clear the feed chute.
Always use food pusher provided.
NOTE
The Pulp Container can be emptied
during juicing by turning the Juicer
OFF and then carefully removing the
Pulp Container. (Replace empty Pulp
Container before continuing to juice).
Do not allow the Pulp Container to
overfill as this may prevent correct
operation or damage the unit.
HINT
To minimize clean up, place a produce
bag into the Pulp Container to collect
the pulp.
OVERLOAD PROTECTION BUTTON
The Breville juicer is fitted with a
safety device which safeguards against
overheating with excessive loads. If this
occurs, the juicer will automatically activate
the overload protection button and the unit
will turn itself off. If this occurs unplug
the Juicer from the power outlet and allow
the unit to cool. Then press the Overload
Protection Button found on the bottom of
the Motor Base. The safety device will then
be reset and the juicer is ready for use again.

   Find Your Products By Category