4.0

Out of 1 Ratings

Owner's of the Sony Camera Flash HVL-F58AM gave it a score of 4.0 out of 5. Here's how the scores stacked up:
  • Reliability

    5.0 out of 5
  • Durability

    4.0 out of 5
  • Maintenance

    5.0 out of 5
  • Performance

    5.0 out of 5
  • Ease of Use

    1.0 out of 5
of 88
 
Applications
65
5
Press the g or G button to make RATIO [OFF] blink.
6 Press the Fn button.
[CTRL+] or [CTRL] is displayed.
Off-camera flash setting:
Set the wireless flash while the flash unit is attached to the camera, and then
remove it from the camera. For details, refer to the operating instructions
supplied with the external flash. When the HVL-F58AM is used as the off-
camera flash, see page 63, and set the remote mode to [RMT].
2 Attach the controller to the camera, and turn on the
power of the camera, controller, off-camera flash.
3 Set up the camera with the controller and the off-
camera flash.
See page 55 for details.
4 Make sure that the controller and the flash unit are fully
charged.
When the flash unit is fully charged in the wireless flash mode, the AF
illuminator on the front blinks, and the TEST button is lit in amber.
5 Use test-flash to check the flash.
The test-flash method differs depending on the camera used. For details,
refer to the operating instructions of your camera.
If the test-flash does not work, change the position of the camera, flash, and
subject, or point the wireless control-signal receiver towards the camera.
Moreover, make sure that wireless channel of the off-camera flash is set to
the same channel as the controller.